Free worldwide shipping. TNT or DHL shipping order request.
Safe payment via PayPal
Carbon battery case for mountainboards or skateboards
• 2 halves (like a soapbox)
• Internal dimensions 245*165*125 (height) mm
• Allow to install 2 controllers + 2 batteries 10S3P
Remote handle controller with transmitter board.
-LCD Display 240x320
-Ability to use safety magnet key
- QI wireless charging
Display: GPS speed, motor RPM, motor/ESC/ battery temperature, battery voltage, stopwatch
Transmitter board specification:
- feeding from traction voltage (up to 60V)
- CAN interface (connection to power ESC)
Jet Pump Housing for Sterk impellers (94 mm)
The position of the water connections on request
Increases pressure in the jet pimp nozzle. More thrust at high RPM.
Inner dimensions: 120 cm x 43 cm х 38 cm
Fits for large manoutiboards with 94cm deck length and 9" wheels
Bag has wheels + straps on the back (can be removed)
Mountainboard deck with strap holes
• 30-degree edge lift
• 10 layers of Maple
• Length 95 cm, width 20 cm,
Mountainboards trucks with 2 hub motors
• 9,5-inch wheel (240х70 mm tyre)
• 250W each motor power (total 500W)
• voltage 10S (36V)
• with hall sensors
• with ESC and wireless handle controller
Outer diameter 95 mm, suitable for Sterk and MSR jet pumps
Titanium bottom, for titanium resonator repair
Unique curved streamlined design, improved original model.
Better stabilization and dynamic stability control.
Foot straps for mountainboard (skateboard)
Allows you to remove the jet pump from the board housing.
Also can press the impeller shaft out of the bearing assembly.